Installation of non-default VxFS and VxVM software version on HP-UX 11i v3 March 2012 Operating Environment Update Release (January 2013)

CASE C: For VxFS/VxVM 5.1 SP1

Base-VxFS-51 Veritas File System Bundle 5.1 for HP-UX

Base-VxTools-51 VERITAS Infrastructure Bundle 5.1 for HP-UX

Base-VxVM-51 Base VERITAS Volume Manager Bundle 5.1 for HP-UX

5. Make any other configuration choices needed using the Ignite-UX interface, and

then select Go to cold-install the client.

Note: You may see the following warning message as part of the Installation. This is expected

and can be ignored.

WARNING: The following was found while selecting software:

- No software in the source depot was found to match the following

software specs:

- Base-VxFS-501,r=B.05.01.03,a=HP-UX_B.11.31_IA/PA,v=HP

Confirming the Client

After the system boots, confirm the client has the intended software and configuration.

To confirm the software and the configuration:

1. Confirm the hostname:

# hostname

The output of the following command shows the hostname:

<you can provide the snapshot of hostname list or just write a sentence. This is a

suggestion>

2. Confirm the OE version:

# swlist | grep HPUX

The output of the following command shows the OE version currently installed

on the system:

3. Confirm installation of the Base VERITAS Volume Manager Bundle for HP-UX 11i

v3:

CASE A: For VxVM 4.1

# swlist Base-VXVM

CASE B: For VxVM 5.0

# swlist Base-VxVM-50

CASE C: For VxVM 5.1 SP1

# swlist Base-VxVM-51

The output of the following command shows the VxVM products installed on the

system.