Veritas Storage Foundation 5.1 SP1 Cluster File System Installation Guide (5900-1510, April 2011)

Install and configure SFCFS. Prepare for your installation according to your

configuration needs.

For preparation:

See “Prerequisites for Veritas Storage Foundation Cluster File System”

on page 39.

For installation:

See “About the Web-based installer” on page 65.

For a multi-node cluster, configure I/O fencing.

■ Verify the shared storage on the secondary site supports SCSI-3

reservations.

■ Set up coordinator disks

■ Configure I/O fencing

For instructions for setting up fencing:

See “About planning to configure I/O fencing” on page 88.

Verify the CVM group is online on all nodes in the primary cluster:

# hagrp -state cvm

Prepare systems and storage for a global cluster. Identify the hardware and

storage requirements before installing your database software.

You will need to set up:

■ Local storage for database software

■ Shared storage for resources which are not replicated

■ Replicated storage for database files

Install and configure the database binaries. Consult your database

documentation.

Note: Resources which will not be replicated must be on non-replicated shared

storage.

After successful database installation and configuration, verify that database

resources are up on all nodes.

Identify the disks that will be replicated, create the required CVM disk group,

volume, and file system.

Setting up a replicated global cluster

Configuring a cluster at the primary site

314