HP CIFS Server Administrator Guide Version A.02.04.04 (5070-6710, October 2011)

likely lead to sharing CIFS Server system data, increasing the likelihood of concurrent file
access and the possibility of CIFS Server corruption.
• Beginning with version A.02.02, HP CIFS Server does not start if another master daemon is
sharing the daemon PID files including a daemon on another node. (By default, PID files are
found in the /var/opt/samba/lock path). CIFS does this to prevent the problems with
sharing the CIFS Server configuration as discussed above.
• Avoid using HP CIFS Server to share Veritas CFS directories simultaneously on multiple nodes.
Since NFS and Veritas CFS provides for multiple nodes to read and write the same files
concurrently, you should use extra caution when configuring HP CIFS Server on multiple nodes
since most locking mechanisms do not span across multiple nodes. Simultaneous file access
can lead to data corruption if multiple producers overwrite each others work.
• The smb.conf parameter strict locking may be set to yes to prevent data corruption
but it may also lead to decrease performance.
By default, since HP CIFS Server provides access to files from multiple clients (and from multiple
nodes sharing an NFS or a Veritas CFS), there is the possibility of concurrent file access and
hence at least a remote chance of data corruption. Therefore, HP CIFS Server provides a "strict
locking" mechanism that can be enabled to prevent concurrent file access. When strict
locking is set toyes in smb.conf, the server checks every read and write access for file
locks, and denies access if locks exist. Since this check will be slow on some systems and well
behaved clients do ask for lock checks when it is important, HP recommends that you set
strict locking to no in smb.conf for most environments. The default value for strict
locking is no.
NetBIOS Names Are Not Supported on Port 445
HP CIFS Server A.02.* versions (based and Samba 3.0.x) can accept connections on port 445
as well as the original port 139. However, since port 445 connections are for SMB over TCP and
do not support the NetBIOS protocol. NetBIOS names are not supported on port 445. This means
features of Samba that depend on NetBIOS will not work. For example, the "virtual server"
technique depending on an "include = /etc/opt/samba/smb.conf.%L" which ends up
referring to another smb.conf.<netbios name> will not work.
You can use the smb.conf parametersmb ports to specify which ports the server should listen
on for SMB traffic. Set smb ports to 139 to disable port 445. By default, smb ports is set to
445 139.
Other Samba Configuration Issues 33