Internet Express for Tru64 UNIX Version 6.10 Administration Guide (5900-1418, March 2011)

Figure 48 Configure FireScreen Menu
Use the Configure FireScreen menu to perform the following tasks:
• Set command-line options (Section : Setting Command-Line Options)
• Set the screening mode (Section : Setting the Screening Mode)
• Add a screening rule (Section : Adding a Screening Rule)
• Check the syntax of screening rules (Section : Checking Syntax of Screening Rules)
• Delete a screening rule (Section : Deleting a Screening Rule)
Note:
You must restart FireScreen for configuration file changes to take effect (Section : Starting and
Stopping FireScreen).
Setting Command-Line Options
To set the command-line options for FireScreen, follow these steps:
1. From the Configure FireScreen menu, choose Set Options.
The current command-line options are displayed, as shown in Figure 49. These command-line
options are passed to FireScreen when it is started.
Figure 49 Default Command-Line Options for FireScreen
The default command-line options specify that:
• The /etc/firescreen.conf file is used to store screening rules and other configuration
information. (This corresponds to the -f option.)
176 Network Security Administration