lanadmin_vlan.1m (2010 09)

lanadmin_vlan(1M) lanadmin_vlan(1M)

(TO BE OBSOLETED)

Interface 5000 is being used by ’ifconfig’

Process ID of application ’ifconfig’ is 8631

Interface 5000 is being used by ’ifconfig’

Process ID of application ’ifconfig’ is 8631

Interface 5000 is being used by ’mib2agt’

Process ID of application ’mib2agt’ is 9010

Interface 5000 is being used by ’scopeux’

Process ID of application ’scopeux’ is 9020

In addition to IP and ARP being conﬁgured on the interface, two applications,

mib2agt and scopeux,

are using the interface. These applications are started during system bootup via the startup scripts

/sbin/rc2.d/S565SnmpMib2

and /sbin/rc2.d/S810mwa

, respectively. To stop these utilities,

run the stop sequence of the scripts. To delete the lan5001 interface, type the following commands:

# ifconfig lan5001 unplumb

# /sbin/rc2.d/S565SnmpMib2 stop

# /sbin/rc2.d/S810mwa stop

Now, lanadmin -p 5001 will not display anything, and the interface can be deleted.

Once the interface is deleted, you can restart the scripts by issuing the start sequence:

# /sbin/rc2.d/S565SnmpMib2 start

# /sbin/rc2.d/S810mwa start

Note: The start and stop sequence of the startup scripts will affect all the interfaces on the system, and

they must be restarted once the delete operation is completed.

The above examples are not restrictive. The applications that use the interfaces depend on your environ-

ment.

WARNINGS

Interactive changes made to VLANs with the lanadmin -V command will not be preserved between sys-

tem reboots. You must use the nwmgr command or ncweb interface (see nwmgr_vlan (1M) and

ncweb(1M)). You can also manually edit the /etc/rc.config.d/vlanconf

conﬁguration ﬁle to

preserve changes across reboots.

Obsolescence

lanadmin, lanscan, and linkloop commands are deprecated.These commands will be removed in a

future HP-UX release. HP recommends the use of replacement command nwmgr(1M) to perform all net-

work interface related tasks.

AUTHOR

lanadmin was developed by HP.