setboot.1m (2010 09)

s
setboot(1M) setboot(1M)
Memory_init on|off on|off
IO_HW on|off on|off
Chipset on|off on|off
The Columns
Test The keyword names of the tests that can be controlled by SpeedyBoot. See The
Tests section below.
Current The current enablement of each test.
on
means the test is normally executed on
each boot.
off means the test is normally omitted on each boot.
partial
means some of the subtests are normally executed on each boot. On Integrity
platform any test modified using the
-T option will be reflected in Current.
Supported Whether the test is supported by the system firmware.
yes means the test is
supported.
no means the test is not supported.
partial means some of the
subtests are supported. On Integrity platform, this Column is not supported.
Default The default values for each test.
on, off, and partial are the same as for
Current.
NEXT BOOT The values for each test that will be used on the next boot. If they are different
from Current, the Current values will be reestablished after the next boot.
on, off, and partial are the same as for Current. On Integrity platform,
this Column is same as that of Current and hence not displayed separately.
The Tests
These are keywords for the hardware tests that are executed by processor-dependent code (PDC) or
firmware upon a boot or reboot of the system.
all All the listed tests.
SELFTESTS Includes the early_cpu and late_cpu tests. This is equivalent to the
SELFTESTS option in the boot console handler (BCH) service menu. The
difference is that setboot can control the subtests separately, while BCH can-
not.
early_cpu When on, run firmware, cache, and CPU-specific tests. Performed out of
firmware. When off, skip the tests.
late_cpu When on, run firmware, cache, and CPU-specific tests. Performed out of
memory and therefore faster than the early_cpu tests. When off, skip the
tests.
FASTBOOT Includes the full_memory and PDH tests on PA-RISC Platform. Includes the
Platform and Full_memory tests on Integrity platform. This is equivalent
to the FASTBOOT option in the boot console handler (BCH) service menu. The
difference is that setboot can control the subtests separately, while BCH can-
not.
Note: When
FASTBOOT is on, the tests are performed, and vice versa.
full_memory When on, run write/read-write/read tests on all memory locations. When off,
only initialize memory. Supported only on PA-RISC Platform.
Platform When on, enables general platform hardware tests. When off, do not. Supported
only on Integrity platform.
Full_memory When on, enables full destructive memory tests. When off, do not. Supported
only on Integrity platform.
PDH Processor-dependent hardware. When on, test a checksum of read-only memory
(ROM). When off, do not. Supported only on PA-RISC Platform.
CEC Central electronic complex. When on, test low-level bus converters and I/O
chips. When off, do not. CEC is not available on all systems. Supported only on
PA-RISC Platform.
Memory_init When on, enables full destructive memory tests. When off, do not. Supported
only on Integrity platform.
2 Hewlett-Packard Company − 2 − HP-UX 11i Version 3: September 2010