setboot.1m (2010 09)

s
setboot(1M) setboot(1M)
section. The -s option is not supported on Integrity system architecture.
-b onoff
Enable or disable the autoboot sequence. The interpretation of Autoboot and Autosearch has
changed for PA-RISC systems that support hardware partitions. Refer to the WARNINGS sec-
tion.
-m onoff
Enable or disable hyperthreading.
-m option is supported only on Integrity system architec-
ture.
-v Display the current values for the primary and alternate boot paths and the
autoboot and
autosearch flags and a status table of the SpeedyBoot tests. See example 1 in the EXAM-
PLES: SpeedyBoot section.
-t testname =value
Change the value for the test testname in stable storage to value for all following boots.
-t
option is not supported on Integrity system architecture. The changes are reflected in the
Current and NEXT BOOT columns of the setboot -v
display.
testname can be one of the following keywords, as described above in the DESCRIPTION:
SpeedyBoot Tests section.
all
SELFTESTS
early_cpu
late_cpu
FASTBOOT
full_memory
PDH
CEC
value can be one of:
on Enable the test.
off Disable the test.
default Reset the test to the system default, which is shown in the Defaults column
of the setboot -v display.
-T testname =value
Change the value for the test testname to value for the next system boot only. The change does
not modify stable storage, so the permanent values are restored after the boot.
testname can be one of the keywords described above in the DESCRIPTION: SpeedyBoot Tests
section. and value are the same as for the
-t option.
RETURN VALUE
The
setboot command returns one of:
0 Successful completion
1 Failure
DIAGNOSTICS
The
setboot command returns the following error messages:
"bootpath" is not a valid bootpath. Bootpaths should be specified with a
persistent dsf, lunpath hardware path or a legacy hardware path.
The boot path, bootpath , should be one of the following: persistent LUN dsf, lunpath hardware
path or legacy hardware path. See ioscan (1M) and intro(7) for more information on hardware path
and persistent dsf format.
cannot open /dev/kepd - message
setboot cannot open the kernel pseudo driver file /dev/kepd. The message explains why.
cannot set autoboot/autosearch flags
The autoboot or autosearch flag could not be set.
cannot set type boot path
4 Hewlett-Packard Company − 4 − HP-UX 11i Version 3: September 2010