Administrator's and User's Guide for SFM HP-UX 11i v3 March 2012
2 Installing the SFM software
The System Fault Management (SFM) software is installed by default with the HP-UX 11i v3
Operating Environment (OE) media. However, at some point you may need to install the SFM
software separately. This chapter describes how to install the SFM software as a standalone
component on the HP-UX 11i v3 operating system.
This chapter discusses the following topics:
• “Prerequisites” (page 18)
• “Installing the SFM software from the media” (page 19)
• “Installing the SFM software from the web” (page 22)
• “Verifying the installation” (page 22)
• “Removing the SFM software” (page 24)
• “Verifying removal of the SFM software” (page 27)
Prerequisites
Starting with HP-UX 11i v3 September 2011 release, SysFaultMgmt and its dependencies are
available through HP-UX WBEM Management Bundle (WBEMMgmtBundle). This Mega bundle
is available only on HP Software Depot. It is recommended to install the products together from
the WBEMMgmtBundle due to the product dependency. For installation steps, see “Installing the
SFM software from the web” (page 22)
Following are the prerequisites for installing the March 2012 version of SFM software:
• HP-UX 11i v3 February 2007 release or later
• OpenSSL Version A.00.09.08g.001 or later
• EVM-EventMgr B.11.31 September 2007 or later
• SysMgmtBase Version B.00.02.03 (Interface) or later
• WBEMSvcs Version A.02.09.02.00 or later
• PHCO_40289 (for Itanium only)
• SysMgmtWeb (HP-UX Web-Based System Management User Interface) Version A.3.0.0.2,
September 2009 release or later
• HP Systems Insight Manager (HP SIM) Version C.06.01 or later
• ProviderSvcsBase Version C.07.00.07.01, March 2012 release or later
• SysMgmtPlus Version A.04.00, September 2010 release or later
• OnlineDiag Version B.11.31.06.xx on HP 9000 systems only, September 2009 release or
later
A.04.20.31EMS Version
D.06.00STM Version
18 Installing the SFM software