Administrator's and User's Guide for SFM HP-UX 11i v3 March 2012

5 Administering indications and instances using HP SMH

This chapter describes the SFM administration tasks that you can perform using HP SMH on a local

system.

This chapter addresses the following topics:

• “Viewing instances” (page 44)

• “Administering indications using Evweb” (page 49)

• “Viewing event subscriptions using Evweb” (page 56)

• “Viewing indications using Evweb” (page 59)

• “Tracing Evweb” (page 67)

• “EMT Overview” (page 71)

• “Querying the Common Error Repository” (page 71)

• “Administering Events in CER” (page 74)

• “Tracing EMT” (page 77)

Viewing instances

This section describes the tasks you must perform to view instances. This section discusses the

following topics:

• “Viewing information about processors” (page 44)

• “Viewing information about memory” (page 45)

• “Viewing information about System Summary” (page 46)

• “Viewing information about Cooling Devices” (page 46)

• “Viewing Power Supply instances” (page 46)

• “Viewing Temperature status and events” (page 46)

• “Viewing Voltage status and events” (page 46)

• “Viewing FRU information” (page 46)

• “Viewing information about Management Processor” (page 47)

• “Viewing information about Firmware information” (page 47)

• “Viewing information about Onboard Administrator” (page 47)

• “Viewing information about Complex-wide info” (page 47)

• “Viewing information about Cell Board” (page 47)

• “Viewing Partition information” (page 47)

• “Viewing information about Blade” (page 47)

• “Viewing information about Cell Blade” (page 48)

• “Viewing Health Test report of Memory” (page 48)

• “Viewing Health Test report of Processors” (page 48)

Viewing information about processors

To obtain information about processors, such as the processor type, architecture revision, and

processor speed, complete the following steps:

44 Administering indications and instances using HP SMH