HP-UX SNAplus2 R7 Administration Guide

Appendix AConfiguration Planning Worksheets
Motif Field Valid Entry/Notes Your Implementation Value
Dependent LU parameters
Host LS/DLUR PU
Name of dependent link station to host or
DLUR PU (must be defined before defining an
LU)
LU number
1–255
This value must match the LOCADDR parame-
ter in the VTAM/NCP LU resource definition
statement.
Member of default pool
Select if needed (only for dependent LU)
Local LU parameters
Support syncpoint
Select if needed
Disable password substi-
tution
Select if needed
Restrict to specific SSCP
Select if needed (only for dependent LU).
The SSCP ID is defined in the SSCPID= field
of the VTAM start list.
Remote Node Dialog: Only configure if the local node is a LEN node.
Node’s SNA network
name
NETNAME.CPNAME (each 1–8 type A
EBCDIC characters)
Partner LU Dialog: Only required for communication with a LEN node, to define a partner LU alias, or if the
local node is a LEN node.
Partner LU name
(NETNAME.LUNAME (each 1–8 type A
EBCDIC characters)
Alias
Up to 8 characters
Uninterpreted name
1–8 type AE EBCDIC characters (if host LU
name is different from PLU name used locally)
Supports parallel sessions
Select if supported
Location
NETNAME.CPNAME (each 1–8 type A
EBCDIC characters)
LS Routing Dialog: Only required if partner LU is located by link station.
LU name
1–8 type A EBCDIC characters
LS name
Up to 8 characters
Partner LU name
(NETNAME.LUNAME (each 1–8 type A
EBCDIC characters)
Use partner LU name as
a wildcard
Select if needed
Mode Dialog: Only required if you are using a nonstandard mode.
Name
1–8 type A EBCDIC characters
190