HP-UX SNAplus2 RJE User's Guide

SNAplus2 RJE Commands
snaprjecan
Chapter 4 101
snaprjecan
The snaprjecan command cancels a job on the spool. The user who
submitted the job must be the same one who cancels it, using the same
user ID.
You must use this command on the computer for which the RJE
workstation is configured, and the SNAplus2 software must be started
on that computer. However, the RJE workstation need not be running.
See your system administrator if necessary or refer to the HP-UX
SNAplus2 Administration Guide for information on RJE workstation
configuration or for information on starting the SNAplus2 software.
Syntax
snaprjecan [-f] [-r] WKST spool id [spool id . . ]
snaprjecan [-f] [-r] WKST ALL
Options
-f
The -f option indicates “force”. Normally, you can
cancel a job only if it is waiting for transmission to the
host. The snaprjecan command will not cancel a job
that is in the process of being sent or that has been
abandoned after a failed attempt to send it. The -f
option forces the job to be cancelled whatever its status.
If you cancel a job with the option after SNAplus2 RJE
has started sending it to the host, sending will
continue. However, if this send attempt fails (for
example, if a connection failure occurs), no retries will
be made. (Normally, SNAplus2 RJE would attempt to
retry up to the maximum retry count if such an error
occurred.)
-r
The -r option indicates “root”. Normally, you can
cancel a job only if you submitted it; that is, you must
have submitted the job with the same user ID that you
used to log on. The snaprjecan command will not cancel
a job that was submitted with a different user ID. The