HP-UX SNAplus2 RJE User's Guide

SNAplus2 RJE Components and Operation
Running the RJE Workstation
Chapter 3 69
Default: The default is a one-minute inactivity time-out
(-s1). If no option is specified, the workstation stops
after one minute of no RJE activity.
Because you may submit jobs at any time regardless of
whether the workstation is running, you may add
further jobs to the spool after you issue the stop
command. The workstation continues to send these
jobs, and does not stop until the spool is empty. It may,
therefore, take some time for the stop command to take
effect. If necessary, you can override this activity by
issuing the stop command again with one of the other
options.
Finish Job (-j)
With this option, the workstation finishes sending the
current job, if any, and then stops. Any other spooled
jobs remain on the spool andmay be sent during a later
run.
Immediate (-i)
With this option, the workstation stops immediately,
even if it is currently sending a job to the host or
receiving data. Since it disrupts both sending and
receiving RJE data, you should only use this option in
error situations.