HP-UX SNAplus2 RJE User's Guide

SNAplus2 RJE Commands
snaprjesend
Chapter 4 85
snaprjesend
The snaprjesend command submits a job file to the RJE workstation
for transfer to the host. It produces a spool file for thenamed workstation
and returns the file ID for this spool file. Normally, the job file will be
searched for the control lines and it will be converted from ASCII to
EBCDIC . You can override these options if required.
You must submit the job on the computer for which the RJE workstation
is configured, and the SNAplus2 software must be started on that
computer. See your system administrator if necessary, or refer to the
HP-UX SNAplus2 Administration Guide for information on RJE
workstation configuration or for information on starting the SNAplus2
software.
The RJE workstation does not have to be running when this command is
issued. The file is simply added to the spool. When the workstation is run
at some later time, it will send the job to the host for processing.
You can also start the workstation at the same time you submit the job
(see “Options” below.) However, this does not guarantee immediate
sending of this job, since other jobs already spooled for this workstation
will be processed first.
Syntax]
snaprjesend [ options ] WKST filename
Options
-b
Indicates that SNAplus2 should treat the job file as a
binary file. Job files will normally be submitted in
ASCII, and SNAplus2 translates them to EBCDIC.
This option overrides the conversion, and sends the file
as submitted. This option remains enabled until the
next end-of-file (EOF) is encountered. No scanning for
control lines occurs with this option. If you specify -b
in the command line, you must specify a file name also.
Only the -q option canbe used in conjunction with this
option.
-c