HP-UX SNAplus2 RJE User's Guide

SNAplus2 RJE Commands
snaprjesend
Chapter 486
Lists control lines to standard error as the file is
interpreted for transmission.
-e
Specifies the use of the RJE exchange device as the
source of the file being sent. Data is sent as a basic
exchange data set with a default record length of 128
bytes.
-f
Folds lower-case characters to upper-case characters.
-h
Lists the input lines to stdout without expanding tabs.
The -h option cannot be used with the -l option.
(Binary data will not be listed.)
-i
Does not scan the input for control lines. This option
remains enabled until the next end-of-file (EOF) is
encountered.
-l
Lists the input lines to stdout. Note that this listing
shows the tabs expanded. The tab size is eight
characters. (Binary data will not be listed.)
-q
Does not submit the file for queuing, but processes the
file normally. This is useful for checking your file before
you queue it for transmission. Use the -q and the -l
options together, or the -q and the -h options together
to display the results of the queuing process to stdout.
-t
Prints the character > on standard error when input
sources are opened.
-y
Suppresses error diagnostics and submits the file
anyway.
-a n