HP-UX SNAplus2 RJE User's Guide

SNAplus2 RJE Commands
snaprjesend
Chapter 488
The name of the RJE workstation in the SNAplus2
configuration file that will process the job. This
parameter must be specified whether or not the
workstation is currently running.
file
The name of the file to be sent. If file is not specified,
input is taken from STDIN. When a file is interpreted
by snaprjesend, each control line must be no greater
than 512 characters and any tabs in the line will be
expanded to eightblanks. Themaximum fully qualified
file name length is 1024 characters. However, for job
spooling and audit logging, the job file name cannot
exceed 200 characters. If the file name exceeds 200
characters, the job will be sent, but the job file name
will not be logged in the audit log file or show in the job
spooler listing.
For job files that are sent as mixed data (-b and -z
options are not used) no one section of data (the job file
or the ind ividual included files) can be larger than 2
gigabytes.
Examples
To send a file namedrocky to the workstation RJE1 withoutany options,
you enter the following:
snaprjesend RJE1 rocky
To view the results of the queuing process for the file rocky without
actually queuing the file, you enter the following:
snaprjesend -q -l RJE1 rocky
or
snaprjesend -ql RJE1 rocky
Using Control Lines
In either form, this command displays the results of the queuing process
on the screen and does not queue the file.
Control lines can be used to modify the source data being sent to the
SNA host. Control lines can be included in the source file or entered from
the terminal depending on the command options being used. A control