HP-UX SNAplus2 RJE User's Guide

SNAplus2 RJE Commands
snaprjelst
Chapter 4 99
The spool ID returned when the job was submitted.
This is the ID required by the snaprjecan command
to cancel the job. For a spooled job, this ID begins with
the characters SPL.
For a job that has been sent to the host (listed using the
-s or -b option), this ID begins with the characters
STS, and is the ID required by the snaprjepur
command to purge the stored status information for
this job.
login name
The login name of the user who submitted the job.
date and time
The date and time when the job was submitted.
status
Status can take the following values:
WAITING - the job has not yet been sent to the host
SENDING - the job is currently being sent
FAILED - the attempt to send the job failed (either the
RJE workstation terminated during sending and has
since been restarted, or it has retried the maximum
number of times without success - see retrycount
below).
SENT - the job has successfully been sent to the host.
If you use the -s option, only jobs in the SENT state
will be listed. If you do not use either -s or -b, only jobs
in the WAITING, SENDING, or FAILED state will be
listed.
maxretry
The number of times the RJE workstation will try to
send the job. Normally, this number is 10; however, it
will retry the maximum number of times specified
when the job was submitted. If it fails after the
maximum number of retries, the Job’s status changes
to FAILED and the job is abandoned.
retrycount