HP-UX Software Assistant Administration Guide (December 2011)

Task Instance Results information is available on this page for each run of the scheduled task.
Selecting the SWA task you scheduled will allow a number of options:
• Run Now – Regardless of the scheduling, run this task immediately.
• Disable – Keep this task and its scheduling information, but do not run the task. This selection
is only available for enabled tasks.
• Enable – Allow this task to run as determined by its schedule. This selection is only available
for disabled tasks.
• Edit – Selecting Edit will take you to the SWA Scheduled Task page as shown below. On this
page you can change the target systems. After your target systems are set, select Next > and
then Schedule to change the scheduling information for this task as described in “Running
your SWA job in HP SIM” (page 33).
• Delete – Removes the scheduled task completely. If you are not sure you want to permanently
delete a task, you can instead Disable it until you are sure.
Authorizing non-privileged users
In an enterprise environment, it might make sense to authorize non-privileged users to run HP SIM
SWA on a specific set of systems without giving those users full access on the HP SIM Central
Management System (CMS). SWA toolboxes are available to enable this – the procedure follows.
Authorizing non-privileged users 37