HP Virtual Connect 1Gb Ethernet Cookbook

Appendix A: Scenario-based Cisco command line reference 84
Simple vNet with Active/Standby Uplinks and Link Aggregation
802.3ad (LACP) - Windows
Connect to the Cisco switch servicing the VC-Enet uplink ports and enter the following IOS
commands.
NOTE: If two switches are being used, issue the same commands on the second switch.
Table 1b Scenario 1 and 2 (Part 2) - Cisco IOS command line configuration.
Command Shortcut Description
>enable >en Privilege mode
#configure terminal #config t Configure via terminal
#interface
gigabitethernet0/1
#int gi1/0/1 Focus on Port 1
#switchport mode
access
#sw mo ac Set Port 1 for Single
VLAN mode
#switchport access
vlan 1
#sw ac vl 1 Allow Port 1 access to
VLAN 1
#channel-protocol lacp #channel-p l Configure Port 1 for
802.3ad LACP
#channel-group 10
mode active
#channel-g 10 mo ac Enable channel group
10
#spanning-tree
portfast trunk
#sp portf tr Enable portfast on Port
1
#exit #ex Remove focus from
Port 1
#interface
gigabitethernet0/2
#int gi0/2 Focus on Port 2
#switchport mode
access
#sw mo ac Set port 2 for Single
VLAN mode
#channel-protocol lacp #channel-p l Configure Port 2 for
802.3ad LACP
#channel-group 10
mode active
#channel-g 10 mo ac Enable channel group
10
#switchport access
vlan 1
#sw ac vl 1 Allow Port 2 access to
VLAN 1
#spanning-tree
portfast trunk
#sp portf tr Enable portfast on Port
2
#exit #exit Remove focus from
Port 2
#exit #exit Exit config mode
#show lacp 10 internal #sh la 10 i Show the LACP group
10 configuration