HP Virtual Connect 1Gb Ethernet Cookbook

Appendix B: Scenario-based ProCurve command line reference 91

Table 4 Scenario 3-6 - ProCurve command line configuration (Tagged VLANs).

Command Shortcut Description

#spanning-tree

ethernet trk1 admin-

edge-port

#span e trk1 admin-

edge

Set Port 1 to be an edge

port (non bridging

port). Note: port is set

by default in “auto-

edge” mode which

automatically sets port

to Edge if no BPDU are

received after 3 sec.

#show vlan 101 #sh vlan 101 Display VLAN 101

#show vlan 102 #sh vlan 102 Display VLAN 102

#show vlan 103 #sh vlan 103 Display VLAN 103

#show vlan 104 #sh vlan 104 Display VLAN 104

#show vlan 105 #sh vlan 105 Display VLAN 105

#show vlan ports trk1

detail

# show vlan ports trk1

detail

Displays the VLAN

detail for Trunk 1

#show interface brief1-

#sh int br1-2 Show Port 1-2 status

#write memory

(For permanent

changes only)

#write mem Save the running

configuration to

NVRAM. Otherwise, the

changes will be lost on

the next reboot.

Note: as ProCurve does not provide the ability to create a bulk set of VLANs, each VLAN must

be created individually. Therefore; create and configure the addition VLANs 2101-2150 as

required.