Manualshelf

HP Virtual Connect for c-Class BladeSystem User Guide

ManualsBrandsHP ManualsComputer AccessoriesHP Virtual Connect 1/10Gb-F Ethernet Module for c-Class BladeSystem
11121314151617181920
Setup 12
3.
Run the Fibre Channel setup wizard ("HP Virtual Connect Fibre Channel Setup Wizard" on page
85).
a. Select a WWN range to be used by server blade FC HBAs ("WWN settings" on page 86).
b. Define the SAN fabrics.
4. Run the Server Profile wizard ("Virtual Connect Manager Server Profile Wizard" on page 91).
a. Define a server profile template.
b. Assign server profiles.
c. Name server profiles.
d. Create server profiles.
After an enclosure is imported into a Virtual Connect domain, server blades that have not been assigned
a server profile are isolated from all networks to ensure that only properly configured server blades are
attached to data center networks.
A server profile can be assigned and defined for each device bay so that the server blade can be
powered on and connected to a deployment network. These profiles can then later be modified or
replaced by another Server Profile ("Server Profiles screen" on page 158).
A server profile can also be assigned to an empty bay to allow deployment at a later date.