HP BladeSystem c-Class Virtual Connect Support Utility Version 1.5.1 User Guide

Introduction 8
Interactive mode question/request Description Reference
Please enter starting IP
address:
(required) First IP address in the
range to search
discover
-s <START IP>
Please enter ending address:
(required) Ending IP address in the
range to search
discover
-s <END IP>
Please enter firmware package
location:
(required) Full path to the Virtual
Connect package on the local
computer
packageinfo
report
update (on page 14)
-l <FILE>
Please enter Bay Number:
(optional) Bay number of the target
module. If not specified, the default is
all supported modules.
report
resetvcm
update (on page 14)
version
-b <BAY>
Please enter the file
location:
(optional) Full path to the
configuration backup or support
dump file
configbackup (on page 11)
supportdump
-l <FILE>
Please enter the
Configuration backup
password:
(optional) Password for the
configuration backup file
configbackup (on page 11)
update (on page 14)
-cp <CONFIG PASS>
Do you want to force an
update on modules? (yes/no):
(optional) Enter Yes to force an
update on modules.
update (on page 14)
-f <FORCE>
Please enter Force Update
options (eg: version,health):
Required only if previous question
was answered yes. Enter options
separated by a comma.
update (on page 14)
-f <FORCE>
Do you want to specify VC-
Enet module activation order?
(yes/no):
(optional) Specify VC-Enet module
activation order
update (on page 14)
-oe <ORDER>
Please enter VC-Enet module
activation order (eg:
parallel or odd-even or
serial or manual):
Required only if previous question
was answered yes. Enter one of the
following: parallel, odd-even, serial,
or manual
update (on page 14)
-oe <ORDER>