HP BladeSystem c-Class Virtual Connect Support Utility Version 1.5.2 User Guide

Introduction 8
Interactive mode question/request Description Reference
for previous question. Enter a
command.
-a <command>
Please enter Onboard
Administrator IP Address:
(required for all commands except
discover and packageinfo) IPv4
address of the active OA in the
primary enclosure
Commands (on page 10)
-i <IP>
Please enter Onboard
Administrator Username:
(required for all commands except
discover and packageinfo) User
name of the active OA in the primary
enclosure
Commands (on page 10)
-u <USER>
Please enter Onboard
Administrator Password:
(required for all commands except
discover and packageinfo)
Password of the active OA in the
primary enclosure
Commands (on page 10)
-p <PWD>
Please enter starting IP
address:
(required) First IP address in the range
to search
discover (on page 11)
-s <START IP>
Please enter ending address:
(required) Ending IP address in the
range to search
discover (on page 11)
-s <END IP>
Please enter firmware package
location:
(required) Full path to the Virtual
Connect package on the local
computer
packageinfo (on page 12)
report
update
-l <FILE>
Please enter Bay Number:
(optional) Bay number of the target
module. If not specified, the default is
all supported modules.
report
resetvcm
update
version
-b <BAY>
Please enter the file location:
(optional) Full path to the
configuration backup or support dump
file
configbackup
supportdump
-l <FILE>
Please enter the Configuration
backup password:
(optional) Password for the
configuration backup file
configbackup
update
-cp <CONFIG PASS>
Do you want to force an update
on modules? (yes/no):
(optional) Enter Yes to force an update
on modules.
update
-f <FORCE>
Please enter Force Update
options (eg: version,health):
Required only if previous question was
answered yes. Enter options
separated by a comma.
update
-f <FORCE>
Do you want to specify VC-
Enet
module activation order?
(yes/no):
(optional) Specify VC-Enet module
activation order
update
-oe <ORDER>
Please enter VC-Enet module
activation order (eg: parallel
or odd-even or serial or
manual):
Required only if previous question was
answered yes. Enter one of the
following: parallel, odd-even, serial,
or manual
update
-oe <ORDER>
Do you want to specify VC-FC
module activation order?
(yes/no):
(optional) Specify VC-FC module
activation order.
update
-of <ORDER>
Please enter VC-FC module
Required only if previous question was update