Manualshelf

HP Virtual Connect for c-Class BladeSystem Setup and Installation Guide

ManualsBrandsHP ManualsComputer AccessoriesHP Virtual Connect 8Gb 24-port Fibre Channel Module for c-Class BladeSystem
41424344454647484950
Installation 44
switchport
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 10,20,30,40
switchport mode trunk
no ip address
speed 1000
channel-protocol lacp
channel-group 10 mode active
Failover and check-pointing
VCM runs as a high-availability pair when VC-Enet modules are installed in horizontally adjacent
interconnect bays. The active VCM is usually on the lowest odd numbered bay when the enclosure is
powered up.
Each time a configuration is changed, it is written to local flash memory and then check-pointed to the
standby module. Configurations can also be backed up to a workstation using the GUI or Virtual Connect
Support Utility.
NOTE: HP recommends saving a configuration after each session and before updating
firmware.