HP Virtual Connect for c-Class BladeSystem Setup and Installation Guide

HP Virtual Connect Manager 56
IMPORTANT: An Onboard Administrator user name and password with full administrative
privileges for the selected enclosure is required.
Enter the user name and password for the enclosure Onboard Administrator. The local enclosure is detected
and selected automatically. If an error appears, it indicates that an invalid Onboard Administrator user name
and password, or one without sufficient privileges, might have been used.
After you import the remote enclosure, the OA IP address must not change. You must always assign a static
IP address or configure it appropriately through your DHCP server.
VCM creates a local user named "vcmuser" on the OA module. Do not modify the credentials for this user.
Do not change the "local users" authentication setting for the OA module.
Enclosure Import/Recovery
After VCM has successfully established contact with the Onboard Administrator, you can create a Virtual
Connect domain by importing the enclosure or by restoring a previously created Virtual Connect domain
from a saved configuration file.
If you plan to use double density server blades, select the "Enable double dense server support (Restricts
single dense server support)" checkbox to display server device bays as double density slots.
This option should only be selected if double-dense servers will be in use. Single-dense servers do not have
access to I/O bays 7 and 8 when this option is selected.
NOTE: This option cannot be modified. After the enclosure is imported, select the Display single
dense device bays checkbox on the Domain Settings (Configuration) screen to display server
device bays as single density slots again.