HP Virtual Connect for c-Class BladeSystem Version 2.30 User Guide

Domain management 32
you cannot use a backup configuration that was created using v1.20.
To back up a domain configuration:
1. Click Backup Configuration.
2. Navigate to the hard drive location for the backup file.
3. Name the file (usually the domain name), and then click Save.
To restore a domain configuration:
1. Enter or browse to the backup file.
2. Select the file.
3. Select the Ignore enclosure serial number in restored configuration file checkbox to restore a
configuration that was generated on another enclosure. If this item is not selected, a configuration
generated on another enclosure is rejected.
4. Select the Disallow restore of 1.1x configuration file checkbox to restore the firmware to a revision
other than what is stored in the configuration file.
5. Click Restore Configuration.
6. Confirm the domain configuration to be restored, and then click OK.
If restoring a configuration file that has multiple enclosures, each remote enclosure must be re-
authenticated for security reasons.
For additional information, see "Recovering remote enclosures (on page 23)."