HP Virtual Connect Manager Command Line Interface for c-Class BladeSystem Version 3.51/3.60 User Guide

Command line 52
Item Description
Destination
(optional)
The IPv4 address or the DNS name of the previously configured remote log
destination
Severity (optional)
Severity of the log messages that should be sent to the specified destination. Valid
values include "Critical", "Error", "Warning", and "Info". The default value is
"Info".
Transport (optional)
The transport protocol to be used for sending the log messages to the destination.
Valid values include "TCP" and "UDP". The default value is "UDP".
Port (optional)
The port to be used on the destination to send the log messages. Valid values
include 1 to 65536. The default value is 514.
Security (optional)
Secure transmission of the log messages. Valid values include "None" and
"STunnel". The Default value is "None", and no encryption is used during
transmission.
The "STunnel" option can be used only if the transport protocol is set to "TCP".
Format (optional)
The timestamp format for the log messages. Valid values include "RFC3164"
(Nov 26 13:15:55) and "ISO8601" (1997-07-16T19:20:30+01:00). The
default value is "RFC3164".
State (optional)
Enables or disables the remote log destination. Valid values include "Enabled"
and "Disabled". The default value is "Disabled".
Examples
->set log-target 1 Severity=Error Transport=TCP
Security=STunnel
Modifies log-target index number 1
->set log-target 1 Destination=192.168.3.1
Modifies log-target at index 1 to use a new IP address
Item Description
show log-target
Display the remote log destination settings.
Syntax
show log-target [<ID|*>]
Parameter
ID (optional)
The index of the remote log destination to view. Use "*" to display detailed
information for all remote log destinations.
Example
->show log-target
Displays all log destination settings
Item Description
test log-target
Send a test message to all enabled remote log destinations.
Syntax
test log-target
Example
->test log-target
Sends a test message all log-targets
loop-protect
Manage loop protection settings.
Supported actions: help, reset, set, show