HP Virtual Connect Manager Command Line Interface Version 2.10 User Guide

Command line 17
Item Description
MacType (optional)
The type of MAC address source to use for assignment. Valid values include "VC-
Defined", "Factory-Default", and "User-Defined".
MacPool (optional)
The pre-defined MAC pool to use for address assignment. Valid values include
integers 1-64. This property is only valid if the MacType is set to "VC-Defined". If
not specified, the default pool ID is 1.
MacStart (Required
if MacType is User-
Defined)
The starting MAC address in a custom user-defined range. This property is only
valid if the MacType is set to "User-Defined".
MacEnd (Required if
MacType is User-
Defined)
The ending MAC address in a custom user-defined range. This property is only
valid if the MacType is set to "User-Defined".
WwnType(optional)
The type of WWN address source to use for assignment. Valid values include
"VC-Defined", "User Defined", and "Factory-Default".
WwnPool(optional)
The pre-defined WWN pool to use for address assignment. Valid values include
integers 1-64. This property is only valid if the WwnType is set to "VC-Defined".
If not specified, the default pool ID is 1.
WwnStart (Required
if WwnType is User-
Defined)
The starting WWN address in a custom user-defined range. This property is only
valid if the WwnType is set to "User-Defined".
WwnEnd (Required if
WwnType is User-
Defined)
The ending WWN address in a custom user-defined range. This property is only
valid if the WwnType is set to "User-Defined".
SingleDense
(optional)
If the imported domain supports double-dense server blades, this property allows
the device bay display format to support the display for single-dense server
blades along with the double-dense server blades. In a double-dense supported
configuration, the default for this property is false, which turns off the display of
single-dense server blades.
Examples
->set domain Name=MyNewDomainName
Changes the name of the Virtual Connect domain
->set domain DomainIp=Enabled
Enables the domain IP address
->set domain DomainIp=Enabled IpAddress=192.168.0.120
SubnetMask=255.255.255.0 Gateway=192.168.0.1
Configures the domain IP address and enables it
->set domain DomainIp=Disabled
Disables the domain IP address and uses DHCP instead
->set domain MacType=VC-Defined MacPool=10
Sets the MAC address source to VC-Defined with a pre-defined range
->set domain MacType=Factory-Default
Sets the MAC address source to use factory default MAC addresses
->set domain MacType=User-Defined MacStart=00-17-A4-77-00-
00 MacEnd=00-17-A4-77-00-FF
Sets the MAC address source to a custom, user-defined address range
->set domain WwnType=VC-Defined WwnPool=5
Sets the WWN address source to VC-Defined with a pre-defined range