HP Virtual Connect Enterprise Manager 6.3 CLI Guide

Table 22 Parameter descriptions for -set iscsi-boot-param (continued)
OptionalRequiredDescriptionParameter
x
NOTE: The
-initiatorname
parameter is required if the
-iscsibootparamdhcp
is set to disabled.
Name used for the iSCSI
initiator on the booting
system. The initiator name
length can be a maximum of
223 characters. If the
initiator name string contains
non-alphanumeric
characters, it should be
enclosed in quotes.
-initiatorname
x
NOTE: The
-initiatorip parameter
is required if the
-networkparamdhcp is
set to disabled.
IP address used by the iSCSI
initiator. This value is in
dotted decimal format.
-initiatorip
x
NOTE: The -mask
parameter is required if the
-networkparamdhcp is
set to disabled.
IP network mask used by the
iSCSI initiator. This value is
in dotted decimal format.
-mask
xDefault IP route used by the
iSCSI initiator. This value is
in dotted decimal format.
-gateway
x
NOTE: The -vlanid
parameter is required if the
-networkparamdhcp is
set to disabled.
VLAN number that the iSCSI
initiator uses for all sent and
received packets. Valid
values include VLAN
numbers between 1 and
4094.
-vlanid
x
NOTE: The -targetname
parameter is required if the
-iscsibootparamdhcp
is set to disabled.
Name of the target from
which to boot. The target
name length is of maximum
223 characters. If the name
string contains
non-alphanumeric
characters, it should be
enclosed in quotes.
-targetname
x
NOTE: The -targetip
parameter is required if the
-scsibootparamdhcp is
set to disabled.
Primary IP address of the
iSCSI target.
-targetip
xThe TCP port associated with
the primary target IP
address. The default value is
3260.
-targetport
xAlternate target IP address
for use if the primary port is
unavailable.
-targetip2
set iscsi-boot-param 53