HP Virtual Connect Enterprise Manager 6.3 CLI Guide

Table 32 VCEM server error messages and descriptions (continued)
Error message descriptionError message number
In the ethernet connection for port, the selected Network
does not exist. The provided Network must exist in the VC
Domain group the Server profile belongs.
2646
A server profile cannot have more than x Ethernet network
connections where x represents a number.
2647
Cannot find FC connection for the specified interconnect
bay because the interconnect bay number is invalid.
2650
Cannot perform server profile operation because the target
server bay is not specified. Select a target server bay and
perform the operation again.
2651
The server profile is configured to use Factory Defaults for
Serial Numbers. Verify no Serial Number and no UUID
are entered when using the Factory Defaults Serial
Numbers.
2655
The port speed information could not be retrieved for the
specified connection. Verify the provided network id
corresponds to an existing network.
2657
In the FC SAN connection for interconnect bay , the base
boot configuration is not set.
2658
In the FC SAN connection for interconnect bay , the
maximum number of boot configurations was exceeded.
2659
In the ethernet connection for port , the port speed is
incorrect. Unassigned ethernet connections must have port
speed set to Preferred.
2660
In the Ethernet connection for port , the port speed is
incorrect. The minimum and maximum port speeds cannot
be empty. The minimum must be lower than or equal to the
maximum, and the values must be a multiple of 100 Mb.
2661
In the ethernet connection for port , the port speed exceeds
the maximum allowed port speed for the selected network
(Gb).
2662
In the ethernet connection for port , the port speed is below
the minimum allowed port speed for the selected network
(Gb).
2663
The provided port speed value is not a valid number.2664
In the FC SAN connection for port number and interconnect
bay , the maximum number of boot configurations was
exceeded.
2674
In the FC SAN connection for port number and interconnect
bay , the specified boot target LUN is invalid. Valid value
is a 3-digit decimal between 0 and 255.
2675
In the FC SAN connection for port number and interconnect
bay , the selected FC SAN fabric does not exist. The FC
SAN fabric must exist in the VC Domain Group the Server
Profile belongs.
2676
In the FC SAN connection for port number and interconnect
bay , the selected port speed is invalid.
2677
75