HP Virtual Connect Enterprise Manager 6.3 CLI Guide

Table 32 VCEM server error messages and descriptions (continued)
Error message descriptionError message number
There are duplicated server VLAN Ids. Type a different
VLAN Id for each mapping.
2729
The provided configuration for multiple networks does not
have the minimal number of VNet mappings. At least one
VNet mapping is required.
2731
There is no VNet selected. Only mappings with a VNet
selected can be marked as untagged
2732
In the FC SAN connection for interconnect bay , the
selected port speed is invalid. Verify that the FC module
of interconnect bay supports the 8Gb downlink speed
value.
2733
The provided network does not exist in the specified VC
Domain Group. The network must exist in the VC Domain
Group to which the Server Profile belongs.
2734
Cannot create Server Profile because an address is already
in use by Server Profile. To resolve this: 1. Access VCEM
and delete the Server Profile with the address reported as
in use, or choose another valid address. 2. Perform the
Create Profile operation again.
2735
There was a problem allocating the address . Possible
causes are: 1. The address is being requested by an
upper-level manager application but it was not reserved.
2. The address is part of an exclusion range. 3. The
address does not belong to any range known to VCEM.
To resolve this, respectively: 1. Verify that the address is
reserved by an upper-level manager application by
checking the owner field of this address. 2. Remove or
adjust the exclusion range to exclude this address. 3.
Create a User-Defined address range that contains all
addresses in use by the Server Profiles. Perform the Create
Profile operation again.
2736
Cannot find iSCSI connection for the specified port because
the port number is invalid. Verify that there is a connection
for the specified port number.
2737
Server Profile has too many iSCSI connections.2738
There is more than one iSCSI connection configured as a
primary Boot Setting. Only one iSCSI connection can be
configured as a primary Boot Setting.
2739
There is more than one iSCSI connection configured as a
secondary Boot Setting. Only one iSCSI connection can
be configured as a secondary Boot Setting.
2740
There is an iSCSI connection configured as a secondary
Boot Setting, but not one configured as a primary Boot
Setting. To have a secondary Boot Setting configured, a
primary Boot Setting must also be configured.
2741
The iSCSI Boot Settings cannot be empty when the iSCSI
connection is configured as primary or secondary.
2742
In the iSCSI connection for port , the port speed is incorrect.
The minimum and maximum port speeds cannot be empty.
They must have the same value, and the value must be a
multiple of 100 Mb.
2743
77