HP Virtual Connect for c-Class BladeSystem Setup and Install Guide

Installation 40
o
If VC-Enet modules are installed in the same enclosure, use VCM to administer VC-FC modules.
o If VC-Enet modules are not installed in the same enclosure, the VC-FC module operates in the default
configuration only.
Installing QSFP+, SFP+ or SFP transceivers
WARNING: To avoid serious injury, never look directly into an open transceiver port.
CAUTION: Disconnect all cables before removing or installing a QSFP+, SFP+ or SFP
transceiver, because of the potential damage to the cables, the cable connector, or the optical
interfaces in the transceiver.
Do not remove and install transceivers more often than is necessary. Doing so can shorten the
useful life of the transceiver.
CAUTION: Do not remove the dust plugs from the fiber-optic QSFP+, SFP+ or SFP transceiver or
the rubber plugs from the fiber-optic cable until you are ready to connect the cable. The plugs and
caps protect the transceiver ports and cables from contamination and ambient light.
To install a transceiver:
1. Remove the dust cap and save it for future use.
IMPORTANT: Use only SFP or SFP+ transceivers approved for the VC module. HP Virtual
Connect FlexFabric-20/40 F8 Modules also support QSFP+ transceivers.
2. Install the transceiver with the label side up. (SFP transceiver shown).
Ensure that the latch is closed and that the transceiver is fully seated.
3. Do one of the following:
o Connect the appropriate cable.
o Install the dust plug onto the transceiver.