HP Virtual Connect for c-Class BladeSystem Version 3.00 Setup and Installation Guide for HP Integrity BL8x0c i2 Series Server Blades

HP Virtual Connect Manager 70
Enter the user name and password for the enclosure Onboard Administrator. The local enclosure is
detected and selected automatically. If an error appears, it indicates that an invalid Onboard
Administrator user name and password, or one without sufficient privileges, might have been used.
After you import the remote enclosure, the OA IP address must not change. You must always assign a
static IP address or configure it appropriately through your DHCP server.
Virtual Connect creates a local user named "vcmuser" on the OA module. Do not modify the credentials
for this user. Do not change the "local users" authentication setting for the OA module.
Enclosure Import/Recovery
After the Virtual Connect Manager has successfully established contact with the Onboard Administrator,
you can create a Virtual Connect domain by importing the enclosure or by restoring a previously created
Virtual Connect domain from a saved configuration file.
If you plan to use double density server blades, select the 'Enable double dense server support (Restricts
single dense server support)' checkbox to display server device bays as double density slots.
This option should only be selected if double-dense servers will be in use. Single-dense servers do not
have access to I/O bays 7 and 8 when this option is selected.
CAUTION: This option cannot be modified. After the enclosure is imported, the only way to
display server device bays as single density slots again is to delete the domain and create a
new one.
For additional information, see "Using double-dense server blades (on page 73)."
Select the appropriate method for creating the Virtual Connect domain.