HP Virtual Connect Version 2.02 Release Notes and Compatibility Matrix

format error. Using the "Upload from web URL" option exclusively prevents this error. If the "Upload
from local file system" must be used, be sure to keep the browser open until the upload completes,
l
• umstances while uploading (staging) a firmware update package, the progress indicator
the
•
te" checkbox is not selected, only modules with lower firmware than the selected package
t" link in the left navigation
•
• essage is displayed, some
ppear
der the
• ircumstances, the primary module might fail to activate after an Automated firmware
the new
ew firmware
Virtual Connect Enterprise Manager Support
• ase of VCEM v1.20 in January 2009 is expected to provide full compatibility and
• For details on the beta availability and final release of VCEM v1.20 software, contact your HP
representative.
For additional information on VCEM, see the
HP website (http://www.hp.com/go/vcem
and avoid attempting firmware updates when the management network is unreliable. To recover
from this error, force a failover of the primary VC Manager or use the Onboard Administrator Virtua
Buttons to reset the primary VC Manager.
In some circ
might appear to be stuck at 0%. Normally, the upload operation completes in a few minutes. If
upload does not complete, the operation times out in 30 minutes, and then the upload can be
restarted.
During automated firmware update, if the primary VC module is running the same or a higher
version than the selected firmware update package, and the "Allow firmware downgrades and/or
re-upda
are updated. Upon completion of any updates, the firmware update page might display inaccurate
version numbers. To correct the display, select the "Firmware managemen
pane.
The OA CLI update all firmware command causes a VC Manager loss of domain, and recovery
requires an OA reset plus VC Manager import of the stale configuration.
During a manual firmware update, if a browser "stack overflow" error m
modules might still be running the previous firmware version and the Activate button does not a
in the firmware update page. If the firmware update page shows the new firmware version un
"Installed" tab, reset the module to activate the new firmware version.
In some c
update. If the primary module fails to activate and the firmware update page shows
firmware version under the "Installed" tab, reset the primary module to activate the n
version.
The planned rele
support for VC firmware v1.3x and v2.0.
).
Known issues 19