HP Virtual Connect 4.20 Release Notes

Prerequisites 8
detects that the identity of the server changed, but VC does not detect the change. As a result, the OA does
not power on the server blade until VC updates the server configuration.
Workaround
To resolve the problem, unassign and reassign the profiles to the two server bays (for example, Bays 1a
and 1b), perform a hot-plug install of the server, or simulate a hot-plug install of the server using the OA
reset server command. The problem can also be resolved if VC restarts, fails over, reboots, receives a
firmware update, or re-evaluates the server after an OA failover.
Issue
Under certain circumstances, the checkpoint status icon in the GUI persists for a long time and is not cleared.
The CLI also shows a "Checkpoint Status: Invalid" status in the show domain command output. This condition
occurs periodically after a VCSU firmware upgrade of the VC module firmware.
Workaround
To resolve this issue, reset VCM on the primary module or reset the primary module using the OA.
Prerequisites
• VC SR-IOV prerequisites:
o Supports the following adapters:
— HP Flex-10 10Gb 2-port 530FLB Adapter
— HP FlexFabric 10Gb 2-port 534FLB Adapter
— HP Flex-10 10Gb 2-port 530M Adapter
— HP FlexFabric 10Gb 2-port 534M Adapter
— HP NC552m Flex-10 Adapter
— HP NC553m 10Gb 2-P FlexFabric Converged Network Adapter
— HP FlexFabric 10Gb 2-port 554M Adapter
— HP Flex-10 10Gb 2-port 552M Adapter
— HP FlexFabric 10Gb 2-port 554FLB Adapter
— HP FlexFabric 20Gb 2-port 630FLB Adapter
— HP FlexFabric 20Gb 2-port 630M Adapter
o Supports the following operating systems:
— Windows 2012 (64-bit)
— VMware ESXi 5.1 U2, 5.5 (64-bit)
— RHEL 5.9 and 5.10 (64-bit with KVM)
— RHEL 6.4 and 6.5 (64-bit with KVM)
— SLES 11 SP2, SP3 (64-bit with KVM)
• The lowest VCEM 7.3.0 support compatibility mode is set to VC 3.30.