HP Virtual Connect Fibre Channel Networking Scenarios Cookbook

136
7. While the server starts up, a screen similar to this one should be displayed:
Defining a Boot from SAN Server Profile using the CLI
You can copy and paste the following commands into an SSH based CLI session with Virtual Connect v3.15; however,
the command syntax might be different with an earlier VC version.
# Create and Assign Server Profile “Profile_1” Booting from SAN to server bay 1
add profile BfS_Profile_1
set enet-connection BfS_Profile_1 1 pxe=Enabled Network=1-management-vlan
set enet-connection BfS_Profile_1 2 pxe=Disabled Network=2-management-vlan
set fcoe-connection BfS_Profile_1:1 Fabric=Fabric_1 SpeedType=4Gb
set fcoe-connection BfS_Profile_1:2 Fabric=Fabric_2 SpeedType=4Gb
set fcoe-connection BfS_Profile_1:1 BootPriority=Primary
BootPort=50:01:43:80:02:5D:19:78 BootLun=1
set fcoe-connection BfS_Profile_1:2 BootPriority=Secondary
BootPort=50:01:43:80:02:5D:19:7D BootLun=1
assign profile BfS_Profile_1 enc0:1
SAN volume correctly
detected during POST by
the two adapters