Manualshelf

HP Virtual Connect Fibre Channel Networking Scenarios Cookbook

ManualsBrandsHP ManualsComputer AccessoriesHP Virtual Connect FlexFabric 10Gb/24-port Module for c-Class BladeSystem
131132133134135136137138139140
138
5. To enable NPIV on this port, click Enable NPIV under the General tab, and then confirm your selection. The NPIV
Enabled entry shows a value of true.
Enabling NPIV using the CLI
1. Initiate a telnet session to the switch, and then authenticate your account. The Brocade Fabric OS CLI appears.
2. To enable or disable NPIV on a port-by-port basis, use the portCfgNPIVPort command.
For example, to enable NPIV on port 13, enter the following command:
Brocade:admin> portCfgNPIVPort 13 1
where 1 indicates that NPIV is enabled (0 indicates that NPIV is disabled).