Manualshelf

HP Virtual Connect Fibre Channel Networking Scenarios Cookbook

ManualsBrandsHP ManualsComputer AccessoriesHP Virtual Connect FlexFabric 10Gb/24-port Module for c-Class BladeSystem
81828384858687888990
84
3. Right-click the port and click Configure…
4. Change the Connection Mode from Disk to Host.
5. Change the Connection Type from Loop to Point and click Ok.
6. Modifying the FC Port configuration can disrupt partner hosts using the same PCI slot. If all of your hosts use a
redundant connection to the 3PAR array, you can click Yes to the warning message. If they don’t, do not
continue until every host is also connected to another 3PAR controller node.
7. Repeat the same steps for the second 3PAR port connected to the second FlexFabric module.