VLS9200 user guide (BW402-10009, August 2012)

Table 28 CLI Configuration Commands (continued)
Usage
1
Command
Lists the current host access mode for all enabled hosts in the system.listAccessMode
Sets the host access mode for all enabled hosts in the system.setAccessMode
Sets the alias for the hostname of the specified host.setAlias
Deletes the specified host from the SAN list.removeHost
Adds the specified device to the host.addLunMap
Lists the host LUN map for specified device.listLunMap
Deletes the specified device from the host.deleteLunMap
Returns the compatibility mode for the virtual serial numbers.getTapeSerialCompatibilityMode
Sets the compatibility mode for the virtual serial numbers. Upgrading to VLS firmware
version 3.3.0 cause the colons in serial numbers to change to periods.
-m <s> - Compatibility mode
setTapeSerialCompatibilityMode
• Standard = default, keeps change of using periods instead of colons
• Legacy = changes periods to back to colons
Returns the firmware version compatibility mode for the WWNNs.getWwnnCompatibilityMode
1
<s> = string; <n> = number; <f> = filename
Management Commands
Use the CLI commands in CLI Management commands to:
• Change the account passwords
• Manage cartridges
• Restart the VLS device emulations
• Save configuration settings
• Restore configuration settings
Table 29 CLI Management Commands
Usage
1
Command
Resets the administrative password, or changes the administrative or user password.
Command View VLS automatically restarts after changing the passwords to make the
changes take effect. Where the options are:
-admin - Reset the administrator password ( -u and -p are ignored) (optional)
changePassword
-p - Password (no spaces) (optional)
-u - Username (administrator or user). Default is current user. (optional)
-h - Displays command usage information (optional)
Changes parameters on an existing cartridge. Where the options are:
-a <s> - VLS filename of the cartridge (required)
editCartridge
-b <s> - Barcode label of the cartridge (required)
-c <n> - Current capacity of the cartridge in gigabytes (optional). Only required if
changing the cartridge capacity.
-l <s> - Name of library in which the cartridge resides (Library_0, ...) (required)
-nc <n> - Desired new capacity of the cartridge in gigabytes (optional)
-nl <s> - Name of the new library if moving cartridge (Library_1, ..) (optional)
-s<s> - Storage LUN name (SLun_#) (required)
-w - Write protect? (0-read/write or 1-read only) (optional)
168 CLI Command Set