VLS9200 user guide (BW402-10009, August 2012)

StatusDescriptionItem

Off = One of these conditions exists:

• No active network cable is connected to the port

• The port is not receiving link beat or sufficient light

• The port has been disabled through the switch console, the web browser

interface, or HP TopTools.

Blinking = If the LED is blinking simultaneously with the Fault LED, the corresponding

port has failed its self test.

Displays network activity information, or whether the port is configured for Full

Duplex operation, or maximum link speed operation, or is experiencing network

events requiring operator intervention depending on the mode selected.

Mode LED9, 11

• If the Activity (Act) indicator LED is lit, each Mode LED displays activity

information for the associated port—it flickers as network traffic is received and

transmitted through the port.

• If the Full Duplex (FDx) indicator LED is lit, the Mode LEDs light for those ports

that are operating in full duplex.

• If the maximum speed (Max) indicator LED is lit, the Mode LEDs light for those

ports that are operating at their maximum possible link speed: 100 Mbps for

10/100 ports and 100-FX fiber-optic ports, and 1000 Mbps for

100/1000Base-T or gigabit fiber-optic ports.

• If the attention (!) indicator LED is lit, each Mode LED lights briefly for each

network event that could require operator attention, for example, late collisions

or CRC errors.

The blinking behavior is an on/off cycle once every 1.6 seconds, approximately.

Ethernet Switch E6600 Components, LEDs, and Buttons

Front Panel Components

DescriptionItem

Console port1

Auxiliary port2

10/100/1000Base-T RJ-45 ports 1 through 24

(numbered from top to bottom, left to right)

10/100/1000 mini-GBIC dual-personality ports 21 through 244

186 Component Identification