VLS9200 user guide (BW402-10009, August 2012)

StatusDescriptionItem
Mode:
The operation of the Mode LED is controlled by the LED Mode select button, and
the current setting is indicated by the LED Mode indicator LEDs near the button.
Press the button to step from one view mode to the next. The default view is Activity
(Act).
When pressed by itself for at least one second, the button deletes any switch console
access passwords that you may have configured. Use this feature if you have
Clear button8
misplaced the password and need console access. This button can be disabled by
a CLI command.
When pressed with the Reset button in a specific pattern, any configuration changes
you may have made through the switch console, the Web browser interface, and
SNMP management are removed, and the factory default configuration is restored
to the switch.
Used to reset the switch while it is turned on. This action clears any temporary error
conditions that may have occurred and executes the switch self-test.
Reset button9
When pressed with the Clear button in a specific pattern, any configuration changes
you may have made through the switch console, the Web browser interface, and
SNMP management are removed, and the factory default configuration is restored
to the switch.
Blinking blue = Locate function is active. Firmware controlled, can be set to on or
blinking.
Locator LED10
Off = Locate function is disabled.
VLS9200 Disk Array Enclosure Components, LEDs, and Buttons
This section provides images and descriptions of the front and rear panels of the VLS9200 disk
array enclosures.
Front Panel Components
DescriptionItem
Drives 0, 1, and 2
(numbered from top to bottom)
1
Drives 3, 4, and 52
Drives 6, 7, and 83
Drives 9, 10, and 114
VLS9200 Disk Array Enclosure Components, LEDs, and Buttons 189