VLS9200 user guide (BW402-10009, August 2012)

StatusDescriptionItem
Blinking green = At least one FC port has I/O activity.Fibre Channel port
activity LED
11
Off = The FC ports have no I/O activity.
Green = The Ethernet link is up.Ethernet link status LED12
Off = The Ethernet port is not connected or the link is down.
Blinking green = The Ethernet link has I/O activity.Ethernet activity LED13
Off = The Ethernet link has no I/O activity.
Green = The port link is connected.SAS port status LED14
Off = The port is empty or the link is down.
1
Some power supply models do not have a power switch. In this case, power down the enclosure by unplugging the
power cords from the enclosure.
Capacity Enclosure
StatusDescriptionItem
Toggle, where O is Off.Power switch
1
1
Green = AC power is on and input voltage is normal.AC Power Good LED2
Off = AC power is off or input voltage is below the minimum threshold.
Yellow = DC output voltage is out of range or a fan is operating below the minimum
required RPM.
DC-Fan Fault/ Service
Required LED
3
Off = DC output voltage is normal.
Blinking white = Expansion controller is selected (for identification purposes only).Unit locator LED4
Off = Not active.
Green = The port link is connected.SAS port 0, input port,
status LED
5
Off = The port is empty or the link is down.
Blue = Not implemented.OK to remove LED6
Yellow = A fault has been detected or a service action is required.Fault/Service required
LED
7
Blinking yellow = A hardware-controlled power on or a cache flush or restore error
occurred.
Green = Expansion controller is operating normally.Power On/OK LED8
Off = Expansion controller is not OK.
Green = The port link is connected.SAS port 1, output
port, status LED
9
Off = The port is empty or the link is down.
VLS9200 Disk Array Enclosure Components, LEDs, and Buttons 193