VLS9200 user guide (BW402-10009, August 2012)

Figure 2 Base and Capacity Enclosure Front Panel LED Status – Normal Operation
LED stateLEDLocationItem
Off or blueStatus (blue or yellow)Hard drives1
On or blinkingPower/Activity (green)2
OffFault/Service RequiredRight ear3
OnPower On/OK4
NOTE: The hard drive LEDs may not immediately illuminate when the enclosure is powered on.
The LEDs illuminate after the hard drives are configured by the VLS firmware.
Figure 3 VLS9000 Base Enclosure Rear Panel LED Status – Normal Operation
LED stateLEDLocationItem
OnAC Power Good (green)Power module1
OffDC-Fan Fault/ Service Required (yellow)2
OnFC link status (L) (green)RAID controller3
OnFC link speed (S) (green)4
OffFault/Service required (yellow)5
OnPower On/OK (green)6
OnEthernet link status (green)7
OnExpansion port status (green)8
90 Operation