hewlett-packard vpn server appliance sa3400 acceleration card upgrade installation notes Hewlett-Packard Company HP: 5971-0876 P/N: A53755-001 March 2001
Disclaimer Information in this document is provided in connection with Hewlett-Packard Company products. No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted by this document.
Except as permitted by such license, no part of this document may be reproduced, stored in a retrieval system, or transmitted in any form or by any means without the express written consent of HewlettPackard Company. Copyright © Hewlett-Packard Company 2001.
Contents INTRODUCTION ..........................................................................................................1 HARDWARE REQUIREMENTS ...................................................................................2 INSTALLING/REPLACING THE ENCRYPTION ACCELERATION CARD IN THE VPN DEVICE ........................................................................................................3 SAFETY PRECAUTIONS ..............................................................................
vi Hewlett-Packard VPN Server Appliance SA3400
Introduction These Hewlett-Packard VPN Server Appliance SA3400 Acceleration Card Upgrade Notes explain how to install the Encryption Acceleration Card into your HP VPN Server Appliance SA3400.
Hardware Requirements This section lists the hardware requirements for installing the Encryption Acceleration Card into your VPN device.
Installing/Replacing the Encryption Acceleration Card in the VPN Device This section explains how to install or replace the Encryption Acceleration card in your VPN device and covers the following topics: • Safety precautions • Removing the cover of the VPN device • Installing/replacing the Encryption Acceleration Card • Closing and securing the cover of the VPN device Safety Precautions WARNING: Turn the power off, disconnect the power cable, and disconnect all other cables before you perform this
Installing/Replacing the Encryption Acceleration Card To install or replace the encryption acceleration card: 1. Remove the screw that holds the slot cover in place in the third slot from the left when you are looking at the rear of the chassis from the outside of the VPN device. 2. Discard the slot cover. 3. Push the Encryption Acceleration Card into the connector, and ensure that it is firmly seated. 4.