hewlett-packard vpn server appliance sa3400/sa3450 regulatory information, hardware installation, and safety notices Hewlett-Packard Company HP: 5971-0870 P/N: A52485-001 March 2001
Disclaimer Information in this document is provided in connection with Hewlett-Packard Company products. No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted by this document.
Except as permitted by such license, no part of this document may be reproduced, stored in a retrieval system, or transmitted in any form or by any means without the express written consent of Hewlett-Packard Company. Copyright © Hewlett-Packard Company 2001.
Contents INTRODUCTION..........................................................................................................1 SPECIFICATIONS................................................................................................................. 1 HARDWARE INSTALLATION.............................................................................................. 1 REGULATORY AND SAFETY..............................................................................................
EUROPEAN REGULATIONS .....................................................................................15 EUROPEAN COMMUNITY (CE) MARK OF CONFORMITY STATEMENT .................... 15 EUROPEAN POWER NOTICES......................................................................................... 16 EUROPEAN REGULATORY INFORMATION................................................................... 17 NOTICE TO UNITED KINGDOM USERS..........................................................................
Introduction This guide contains safety and regulatory information for the HP VPN Server Appliance SA3400/SA3450 as well as hardware installation instructions. Read through this information before installing the HP VPN Server Appliance SA3400/SA3450.
Physical Specifications The following table contains the physical specifications for the HP VPN Server Appliance SA3400/SA3450. Feature 2 Measurement U.S. or Imperial Units Metric Units Width 16.75 in. 42.54 cm Length 18.5 in. 46.99 cm Height 7 in. 17.78 cm Weight (maximum configuration) 33 lbs. 14.
Environmental Specifications The following table contains the environmental specifications for the HP VPN Server Appliance SA3400/SA3450. Feature Measurement U.S. or Imperial Units Metric Units Altitude Up to 15,000 ft.
Electronic and Electrical Specifications VAC and Connector Specifications The following table contains the VAC electrical and connector specifications for the HP VPN Server Appliance SA3400/SA3450. Feature Specifications Connectors 1 power cord connector 1 or 2 twisted-pair (10BaseT, 100BaseTX, RJ-45) Ethernet connectors The rear panel has two RS232 DB-9 male connectors for serial cables to a terminal or for modems with rates up to 115.2 Kbps. Power requirements 100 – 240 VAC 4.6 – 2.
Cooling Requirements To provide proper cooling, the HP VPN Server Appliance SA3400/SA3450 has air vents on the rear panels, and a cooling fan located inside the front panel and the power supply. Plan to leave a minimum clearance area of 2 inches (5 centimeters) around the side and rear panels. When you route cables from the HP VPN device, be sure to avoid blocking the air vents and fan.
Hardware Installation Mounting Options The HP VPN Server Appliance SA3400/SA3450 has the following mounting options: • Standalone device • Stationary rack Standalone Device You can place the HP VPN Server Appliance SA3400/SA3450 on a secure surface as a standalone unit. Stationary Rack The HP VPN Server Appliance SA3400/SA3450 ships with rack mounting ears. Install the ears in the appropriate position for your communications rack and mount the unit.
Reliable earthing (grounding) of the unit should be maintained. Particular attention should be given to supply connection other than direct connections to the branch circuit (such as power strips). CAUTION: Ensure that a reliable earth ground is provided for the rack. Cabling Requirements The HP VPN Server Appliance SA3400/SA3450 ships with a power cable and a DB-9 admin cable. The power cable is 6.5 feet (198 centimeters) in length, and the DB-9 Admin cable is 65 inches in length (160 centimeters).
Installing/Replacing Network Interface Cards The following topics describe how to remove and install network interface cards (Ethernet or serial) from the HP VPN Server Appliance SA3400/SA3450: • Removing the Cover • Installing/Replacing a Network Interface Card • Closing the Cover Safety Precautions WARNING: Turn the power off, disconnect the power cable, and disconnect all other cables before you perform this procedure.
Installing/Replacing a Network Interface Card 1. Remove an existing card from either slot (1 or 2) by unscrewing the Phillips-head screw from the top of the card. 2. Remove the card from the slot. 3. Insert the new card into the slot. 4. Ensure that the card is seated securely in the slot. 5. Replace the Phillips-head screw that you removed from the old network interface card in the top of the new network interface card. Closing the Cover 1.
Connecting the Cables To properly configure the cables and connectors on the HP VPN Server Appliance SA3400/SA3450: 1. Remove the power cable from its packaging. 2. Connect the power cable to the IEC connector on the rear panel of the chassis. 3. The HP VPN device has slots for either two Ethernet ports, or one Ethernet port and one serial card with two interfaces located on the rear panel. Connect the Ethernet (ferrite) cables supplied with the system to the 10BaseT or 100BaseTX Ethernet RJ-45 connector.
Regulatory Statements for the HP VPN Server Appliance SA3400/SA3450 The following sections describe safety and regulatory information for the HP VPN Server Appliance SA3400/SA3450. Read through this information before installing the HP VPN device in your network.
Federal Communications Commission Warnings and Service Requirements FCC Warnings The HP VPN Server Appliance SA3400/SA3450 has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
Service Requirements Do not attempt to repair or modify the HP VPN Server Appliance SA3400/SA3450. In the event of equipment malfunction, all repairs to the HP VPN Server Appliance SA3400/SA3450 should be performed by Hewlett-Packard Company or a Hewlett-Packard Company-authorized representative. It is the responsibility of users requiring service to report the need for service to Hewlett-Packard Company.
Canadian Regulations Canadian Equipment Identification Requirements This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the interference-causing equipment standard entitled: Digital Apparatus, CES-003 of Industry Canada.
European Regulations European Community (CE) Mark of Conformity Statement This product is in conformity with the protection requirements of EC Council Directive 89/336/EEC on the approximation of the laws of the Member States relating to electromagnetic compatibility. Hewlett-Packard Company cannot accept responsibility for any failure to satisfy the protection requirements resulting from a nonrecommended modification of the product, including the fitting of non-Hewlett-Packard Company option cards.
A signed copy of the Declaration of Conformity is on file and is available from Hewlett-Packard Company. Dieses Gerät ist berechtigt in Übereinstimmung mit dem deutschen EMVG vom 9.Nov.92 das EGKonformitätszeichen zu führen. Der Außteller der Konformitätserklärung ist die Hewlett-Packard Company, Route du Nant-d'Avril 150, CH-1217 Meyrin 2, Geneva, Switzerland. Dieses Gerät erfüllt die Bedingungen der EN 55022 Klasse B. European Power Notices CAUTION: No user serviceable parts inside power supply cover.
IMPORTANTE Para operacion a 230 VAC, ten quidado usarse un alambre armoniziado & conectado con la tierra, potencia nominal de 6 Amp, con un cordon propiamente terminada para conexion al equipaje y el otro cordon que esta terminando en una clavija de conexion IEC visto bueno para conexion al circuito gajo. VORSICHT: In der Stromversorgungsabdeckung befindliche Teile können nicht vom Benutzer gewartet werden. Die Wartung ist ausschließlich qualifiziertem Wartungspersonal zu überlassen.
Japanese Regulations Japanese Voluntary Control Council for Interference (VCCI) Statement The HP VPN Server Appliance SA3400/SA3450 is in the B Class category (information equipment to be used in commercial and/or industrial areas) and conforms to the standards set by the Voluntary Control Council for Interference by Information Technology Equipment aimed at preventing radio interference in commercial and industrial areas.
German Regulations Warnungen Das Wort 'Warnung' erscheint immer dann, wenn Verletzungsgefahr für Personen oder ein Beschädigungsrisiko für Geräte besteht. Leisten Sie in einem solchen Fall den Anweisungen Folge. Elektrostatische Entladung Eine elektrostatische Entladung vom Betriebspersonal an den Computer kann das Gerät beschädigen.
Umgang mit Kabeln Fassen Sie Kabel beim Anschließen und Abziehen immer am Stecker an. Interaktion mit anderen Geräten Sollen andere Komponenten, einschließlich Kabel, zwischen dem Gerät und dem Anschlußpunkt an einen digitalen Circuit angeschlossen werden, müssen alle anderen Komponenten den folgenden Richtlinien entsprechen: 1.
Safety Notices DANGER: Only Hewlett-Packard Company-qualified technicians are authorized to service the unit. DANGER: To avoid shock hazard: • Ensure that the power cord is connected to a properly wired and grounded receptacle. • Do not connect or disconnect any cables or perform installation, maintenance, or reconfiguration of this product during an electrical storm. • Ensure that any equipment to which this product will be attached is also connected to properly wired receptacles.
FARE: For å unngå elektrisk støt må ikke kabler kobles til eller fra. Du må heller ikke foreta installering, vedlikehold eller rekonfigurering av dette produktet i tordenvær. FARE: For å unngå elektrisk støt: • Nettkabelen må være plugget i en korrekt koblet og jordet stikkontakt. • Alt utstyr som er koblet til dette produktet må være plugget i en korrekt koblet stikkontakt. FARE: Slå av nettspenningen og trekk nettkabelen ut av stikkkontakten før du kobler signalkabler til eller fra.
• moeten alle machines waarmee dit product zal worden verbonden ook op correcte bedraden stopeontacten zijn aangesloten. GEVAAR: Zet de netschakelaar op O (Uit) en trek de stekker uit het stopcontact vooraleer u signaalkabels losof vastkoppelt. VORSICHT: Aus Sicherheitsgründen bei Gewitter an diesem Gerät keine Kabel angeschließen oder lösen. Ferner keine Installations-, Wartungs oder Rekonfigurationsarbeiten durchführen.
PERICOLO: La manutenzione dell'unità deve essere consentita solo a tecnici qualificati per Hewlett-Packard Company. PERICOLO: Per evitare scosse elettriche, non collegare o scollegare cavi o effettuare installazioni, riconfigurazioni o manutenzione di quest prodotto durante un temporale. PERICOLO: Per evitare scosse elettriche: • Il cavo di alimentazione deve essere collegato a una presa munita di terra di sicurezza e propriamente cablata.
PELIGRO: Para evitar la posibilidad de descargas, no conecte o desconecte ningún cable, ni realice ninguna instalación, servicio de mantenimiento o reconfiguración de este producto durante una tormenta eléctrica. PELIGRO: Para evitar el peligro de descargas: • Los cables de alimentación deben estar conectados a receptáculos con conexión a tierra y cableado adecuados. • Todos los equipos a los que se conecte este producto también deberán conectarse a receptáculos con el cableado adecuado.
• Tähän laitteeseen liitettävät laitteet on kytkettävä toimintakunnossa olevaan maadoitettuun pistorasiaan. VAARA: Katkaise virta ja irrota verkkojohto pistorasiasta, ennen kuin kyket tai irrotat liitäntäkaapeleita.