HP Cache Server Appliance Administrator Guide

146
Appendix C Traffic Line Commands
Traffic Line interactive mode commands
Use interactive mode to retrieve statistics and to configure the Traffic Server system.
To access interactive mode, enter
traffic_line -i at the prompt. The following table describes the
commands available in interactive mode.
traffic_line -B Bounces the Traffic Server cluster wide. Bouncing
the Traffic Server shuts down and immediately
restarts Traffic Server node by node.
traffic_line -b
Bounces the Traffic Server on the local node.
Bouncing the Traffic Server shuts down and
immediately restarts the Traffic Server node.
traffic_line -T value
Sets the amount of time that Traffic Line waits to
receive a response to a command from the Traffic
Server. value specifies the time in seconds.
NOTE If there is a number associated with a command, enter the number only at the prompt.
For example, to access Monitor mode, enter
1 at the prompt
Command (name) Description
1 (monitor) Displays the Monitor mode commands so that you can view Traffic Server
performance and network traffic statistics. Refer to Chapter 9‚ Monitoring Traffic.
2 (configure) Displays the Configure mode commands so that you can configure the Traffic
Server system. Refer to Chapter 10‚ Configuring Traffic Server.
3 (reread) Re-reads the configuration files.
NOTE: Some configuration changes require that you initiate a configuration re-
read for the changes to take effect.
4 (shutdown) Shuts down the Traffic Server.
5 (startup) Starts the Traffic Server.
6 (bounce_local) Bounces the Traffic Server on the local node. Bouncing the Traffic Server shuts
down and immediately restarts the local node.
7 (bounce_cluster) Bounces the Traffic Server cluster wide. Bouncing the Traffic Server cluster shuts
down and immediately restarts the Traffic Server node by node.
8 (restart _local) Restarts the
traffic_manager process on the local node.
9 (restart _cluster) Restarts the
traffic_manager process on all the nodes in the cluster.
help Displays a list of commands for the active level.
You can use the help command at any Traffic Line interactive level. Enter either
help or ? at the prompt to open the command list.
exit Exits interactive mode.
. Moves back to the previous command level.
Command Description