HP StoreEasy 1000 Storage Quick Start Guide (B7D88-96110, April 2014)

NOTE: When connecting to the storage system
to complete the initial setup, ensure that no
external disk enclosures are connected to the
storage system. Otherwise, the OS drive could be
created on the disk enclosure if any drive on the
disk enclosure is labeled “system” and would
prevent storage provisioning from occurring.
• Direct attach —This access method is mandatory if
your network does not have a Dynamic Host
Configuration Protocol (DHCP) server. Connect the
following cables to the back panel of the storage
system in the following sequence: keyboard, mouse,
network cables, monitor cable, and power cable.
NOTE: The keyboard, mouse, and monitor
are not provided with the storage system.
• Remote management—Access the storage system
using the Integrated Lights-Out (iLO) remote
management method:
1. Connect the desired network cables to network
adapter ports on the back of the storage
system.
2. Connect a network cable to the iLO port
located on the back of the storage system.
3. Connect a power cable to the storage system.
4. Locate the iLO Network Settings tag attached
to the storage system and record the default
user name, password, and DNS name.
5. From a remote computer, open a standard
Web browser and enter the iLO management
hostname of the storage system.
NOTE: By default, iLO obtains the
management IP address and subnet
mask from your network’s DHCP server.
The hostname found on the iLO tag is
automatically registered with your
network’s DNS server.
6. Using the default user information provided on
the iLO Network Settings tag, log on to iLO,
and then launch a remote console to the
storage system.
For detailed instructions about using each of these access
methods, see the HP StoreEasy 1000 Storage
Administrator Guide or the HP iLO 4 User Guide, which
you can search for (by product name) at:
http://www.hp.com/support/manuals
Power on and complete the configuration
1. Power on the system by pushing the power button
on the front panel. If using iLO, click Momentary
Press under the Power Switch menu of the remote
console.
The storage system starts and displays the Setup
Windows wizard.
NOTE: In case of clustered profile you
needs to install and interact on both the
nodes till you get the notification to select
clustered/standalone profile for the system.
2. Select the desired language and click Next.
3. Accept the license agreement and click Accept.
4. Select the desired region, language settings, and
keyboard layout and click Next.
5. When prompted, enter a password of your choice.
It should be a password you can remember.
6. When prompted, press CTRL+ALT+DELETE to log
on to the system. If using iLO, click the Ctrl-Alt-Del
menu item in the Keyboard menu of the remote
console.
7. When prompted, enter the default Windows
Administrator password (which is HPinvent!).
You are then prompted to change the default
Windows Administrator password. Enter and
re-enter the password of your choice.
The installation process continues until complete,
which takes approximately 10–15 minutes. When
the installation completes, the server reboots.
8. When prompted, press CTRL+ALT+DELETE to log
on to the system.
The HP Initial Configuration Tasks (ICT) window launches
automatically at logon. Use the ICT to perform setup
tasks such as setting the time zone, network
configuration, changing the computer name, joining a
domain, and provisioning storage. For more information
on any of these tasks, click the help icon for the
appropriate task group in the ICT window.
Regulatory information
For important safety, environmental, and regulatory
information, see Safety and Compliance Information for
Server, Storage, Power, Networking, and Rack Products,
available at http://www.hp.com/support/
Safety-Compliance-EnterpriseProducts.
Documentation feedback
Send any errors, suggestions, or comments to
Documentation Feedback ([e-mail]).
Page 2