2.03.1a HP X5000 G2 Network Storage System Release Notes (QW919-96053, December 2012)

NOTE:
• If you launch more than one instance of the executable, an incorrect error message is
displayed. Instead of indicating that another instance is running, the following error message
is displayed:
7 zip, internal error, code 105
• When you are prompted to reboot during the installation, the "Installation is complete"
message displays in the installer window with two checkboxes—Cleanup and Reboot (both
selected by default). Because more than one reboot is required during installation, HP
recommends that you uncheck the Cleanup box until you have finished the installation. If you
forget to run the cleanup, you can run the service release installer again. The installer returns
to the point in the process where you previously stopped.
4. Copy ServiceRelease_swx_2.03.1a.exe from the server blade in Bay 1 to the server blade
in Bay 2 and repeat steps 2 and 3 on that server blade.
5. Open System Manager on the server blade in Bay 1 and check for firmware updates on the
Firmware tab. Update any firmware that is listed. Then, run
ServiceRelease_swx_2.03.1a.exe on both server blades again (one at a time) to ensure
the service release installation is complete.
On rare occasions, the reboot after completing the service release installation may take approximately
30-40 minutes to complete.
NOTE: After installing the service release and rebooting, the service release installer shortcut is not
removed automatically from the desktop. No action will occur if you click the shortcut. You can delete
the shortcut.
Effective date
December 2012
Effective date 13