5.5 HP StorageWorks X9720 Network Storage System Administrator Guide (AW549-96026, March 2011)

11. Perform the following steps For each X9700c controller in turn:
a. Slide out controller until LEDs extinguish.
b. Reinsert controller.
c. Wait for the seven-segment to show "on".
d. Run the exds_stdiag command on affected server.
e. If ok, the procedure is completed; otherwise, repeat steps a through d on next the controller.
12. If the above steps do not produce results, replace the HP P700m.
13. Boot server and run exds_stdiag,
14. If you still cannot see the X9700c controllers, repeat the procedure starting with step 1.
If the system is not in production, you can use the following shorter procedure:
1. Power off all server blades.
2. Using OA, power off both SAS switches.
3. Power on both SAS switches and wait until they are on.
4. Power on all server blades.
5. Run exds_stdiag. If exds_stdiag indicates that there are no problems, then the procedure
is completed; otherwise, continue to the next step.
6. Power off all X9700c enclosures.
7. Power on all enclosures.
8. Wait until all sever-segment displays show "on" then power on all server blades.
9. If the HP P700m still cannot access the fabric, replace it on affected server blades and run
exds_stdiag again.
X9700c enclosure front panel fault ID LED is amber
If the X9700c enclosure fault ID LED is amber, check to see if the power supplies and controllers are
amber. If they are not, wait until a suitable time and power cycle the capacity block. In the meantime,
the enclosure fault LED can be ignored. If the power supplies and controllers are amber, see the HP
StorageWorks X9720 Extreme Data Storage System Controller User Guide for troubleshooting steps.
Spare disk drive not illuminated green when in use
Spare disk drives might not always be illuminated green, even when they are in use.
IMPORTANT:
Do not remove a disk drive unless the fault/UID LED is amber.
Replacement disk drive LED is not illuminated green
When a disk drive is replaced and the LUN is rebuilt, the online/activity LED on the replacement disk
drive might not be illuminated green. However, activity on the disk will cause the online/activity LED
X9720 Network Storage System Administrator Guide 127