5.5 HP StorageWorks X9720 Network Storage System Administrator Guide (AW549-96026, March 2011)

6. From the active management console node, verify that the new version of X9000 Software FS/IAS
is installed on the file serving nodes:
<ibrixhome>/bin/ibrix_version -l –S
Completing the upgrade
1. Remount the X9000 Software file systems:
<ibrixhome>/bin/ibrix_mount -f <fsname> -m </mountpoint>
2. From the node hosting the active management console, turn automated failover back on:
<ibrixhome>/bin/ibrix_server -m
3. Confirm that automated failover is enabled:
<ibrixhome>/bin/ibrix_server -l
In the output, HA should display on.
4. From the node hosting the active management console, perform a manual backup of the upgraded
configuration:
<ibrixhome>/bin/ibrix_fm -B
5. Upgrade X9000 Clients:
• For Linux clients, see Upgrading Linux X9000 clients, page 94.
• For Windows clients, see Upgrading Windows X9000 clients, page 95.
6. Verify that all version indicators match for file serving nodes and X9000 Client. Run the following
command from the active management console:
<ibrixhome>/bin/ibrix_version –l
If there is a version mismatch, run the /ibrix/ibrixupgrade -f script again on the affected
node, and then recheck the versions. The installation is successful when all version indicators
match. If you followed all instructions and the version indicators do not match, contact HP Support.
7. Verify the health of the cluster:
<ibrixhome>/bin/ibrix_health -l
The output should show Passed / on.
8. If you received a new license from HP, install it as described in the “Licensing” chapter in this
guide.
Upgrading Linux X9000 clients
Be sure to upgrade the management console and file serving nodes before upgrading Linux X9000
clients. Complete the following steps on each client:
1. Expand the upgrade tarball or mount the upgrade DVD.
2. Run the upgrade script:
./ibrixupgrade -f
The upgrade software automatically stops the necessary services and restarts them when the up-
grade is complete.
3. Execute the following command to verify the client is running X9000 Software:
/etc/init.d/ibrix_client status
IBRIX Filesystem Drivers loaded
IBRIX IAD Server (pid 3208) running...
Upgrading the X9000 Software94