6.5 HP StoreAll 8200/9300 Storage Administrator Guide

Managing power sources
To view the power source for a server, select the server on the Servers panel, and then select Power
from the lower Navigator. The Power Source panel shows the power source configured on the
server when HA was configured. You can add or remove power sources on the server, and can
power the server on or off, or reset the server.
Adding a NIC
On the Add NIC dialog box:
1. Complete the following fields as needed:
NOTE: Name and IP Address are required fields.
• Name: To configure an active physical network, enter the name of the existing physical
interface, such as eth4 or bond1). To configure a virtual interface (VIF), enter a name
based on the existing physical network, such as bond0:1.
• Net Mask: Enter the net mask for the subnet. The default is 255.255.255.0.
• Route: Each network interface has an entry in the system routing table for handling traffic.
If you enter a new route (IP address) for the interface, it overwrites any current entry for
this interface.
• MTU: Maximum Transfer Unit for Ethernet. Leave blank to use the standard MTU value.
2. Click OK when finished.
46 Configuring failover